Strong Lighting SUPER TROUPER III, Инструкция по эксплуатации

Страница: 19 / 46

MAINTENANCE
THE SUPER TROUPER
III
SPOTLIGHT SYSTEM requires very little maintenance to
keep it in good working order. Routine cleaning is generally sufficient.
THE REFLECTOR and the heat filter should be cleaned periodically with a clean, soft, lint
free cloth to remove any dust from the coated surfaces. If excessively soiled, use a commercial liquid glass
cleaner
that does not contain ammonia
.
THE XENON LAMP should be checked occasionally for presence of any foreign material
on the envelope. Any dirt or other foreign material will rapidly burn into the quartz material and possibly
shorten bulb life. Use isopropyl alcohol and a clean, lint-free cotton cloth to remove dirt, fingermarks, and
other contaminants.
CAUTION:
Observe all safety procedures when working around the exposed lamp .
CHECK ALL ELECTRICAL TERMINATIONS periodically for tightness. Note especially
the xenon lamps connections and other leads in the DC circuit.
THE INSIDE OF THE LAMPHOUSE COMPARTMENT and the lamphouse cover louvers
should be cleaned periodically, depending on the dust conditions at each installation. The blower air inlets
in the bottom panel may require cleaning to remove dust build-up which accumulates over a period of time.
If dust build-up impedes the blower
impellers
, or if obstructed air flow allows the
squirrel cage
blower
motor to overheat, a thermal switch in the blower motor will shut down the blower. If the
squirrel cage
blower shuts down repeatedly, it is necessary to dismount it from the spotlight base rail for a thorough
cleaning. Vacuum or blow out the (2)
impellers
and lubricate the blower motor in the marked oil holes.
The six-inch box fan at the rear of the lamphouse requires no lubrication.
THE OPTICAL SYSTEM LENSES must be kept clean to prevent any light reduction in
the projected spot. To gain access to the lenses, tighten the horizontal pan and vertical tilt locking clamps,
and remove the color boomerang and optical system housing.
CLEAN THE OPTICAL SYSTEM LENSES using lint-free lens tissues with any
cleaner approved for use on coated projection lenses. If the projection lens assembly is removed from its
barrel for cleaning, replace the lens with the arrow (engraved on the lens barrel) pointing toward the iris.
WHEN TRANSPORTING the spotlight from one venue to another, it is recommended that
the xenon lamp be removed and placed in its original shipping carton with the cover on to insure
against break-age. If the spotlight is moved from one position to another within the same venue, the unit
may be transported with the lamp installed, assuming reasonable care is exercised.
DO NOT
move the
spotlight until the bulb has cooled to room temperature. It is permissible to transport the follow spot from
venue to venue with the lamp installed so long as the road case used to move the fixture has be designed to
protect the follow spot from major bumps and vibration.
ST3 /017