Strobel 327D, Руководство по эксплуатации

Страница: 22 / 38

18
BA_327D_A2_200715_en.doc
4.4 Winding up the thread (Fig. 7)
The course of the thread during winding up is shown in Fig. 7.
Care must be taken that not too much of the thread is wound onto the bobbin and
that the bobbin walls are not pushed apart, faulty bobbins must immediately be
replaced with new ones.
Fig. 7
4.4.1 Installing the bobbin and threading the bobbin thread (Fig. 8)
By turning the needle lever to its highest position with the hand wheel, the bobbin (1)
can be taken out and reinserted. Fold the bobbin holder flap away from the bobbin
capsule with a short jerk, the bobbin then jumps by spring pressure out of the bobbin
capsule so that it can be easily removed. Make sure that the spool brake (2) is not lost!
When inserting the bobbin take care that the bobbin thread unwinds from the
underside of the bobbin. Then guide the start of the bobbin thread through the slot at
the right hand side of the bobbin capsule and hold it lightly at the stitch plate.
Then turn the hand wheel of the machine a full rotation and at the same time hold the
needle thread lightly tensioned after take up by the hook point. This pulls the bobbin
thread correctly under the leaf spring.
It is best to then lightly twist together the needle thread and the bobbin thread and
pull them together to the back through the stitch plate hole.