Strend Pro DIX-020Y, Инструкция по эксплуатации, Страница: 21 / 24

EN
Maintenance (Continued)
NOZZLES:
Nozzles should be cleaned or replaced at least once per
heating season. Contaminated fuel could make this
necessary immediately
.
To clean dirt from nozzle, blow
compressed air through nozzle front. It may be necessary to
soak nozzle in clean 1-K kerosene to help loosen any
particles.
NOTE: Use of diesel may require additional maintenance.
Using this heater without proper maintenance or with
contaminated or old fuel may lead to improper combustion
and possible soot production.
Figure 8. Nozzle Or Spark Plug Replacement
SPARK PLUG:
Clean and re-gap every 600 hours of operation, or replace
as needed. After removing the Spark Plug, clean the
terminals with a wire brush. Re-gap the terminals to 3.5mm.
see Figure 8 .
PHOTOCELL:
The Photocell should be cleaned at least once per heating
season or more depending on conditions.
Use a cotton swap dipped in water or alcohol to clean the
lens of the Photocell. Note the proper Photocell position as
noted in
Figure 9
Figure 9. Photocell Position
FUEL FILTER:
The Fuel Filter should be cleaned at least twice per heating
season by rinsing it in clean 1-K kerosene. Contaminated
fuel could make this necessary immediately (See
Figure
10 ).
Use of diesel may require additional maintenance.
Improper maintenance can lead to poor combustion
and soot production.
Figure 10. Fuel Filter Replacement