Strend Pro DIX-020Y, Инструкция по эксплуатации, Страница: 20 / 24

EN
TO START THE HEATE
Maintenance
1. Fill the tank
with kerosene until fuel gauge points to “F”.
2. Be sure fuel cap is secure.
3. Plug power cord into prong, grounded extension cord
and plug extension cord into prong 220-240V grounded
outlet.
4. Turn thermostat control knob to desired temperature
setting. The setting range is from 5
℃
to 45
℃
. Push the
Power switch to the “ON” position (See figure 5).The power
indicator lamp and room temperature display will light and
the heater will start.
NOTE: If the heater does not fire, the thermostat may be set
too low. Turn the Control Knob to a higher setting until
heater fires. If the heater still does not start, push Power
Switch to “OFF”, then back to “ON”. If heater still does not
fire, see
Troubleshooting Guide.
NOTE: The electrical components of this heater are
protected by a fuse mounted in the PC board. If the heater
fails to fire, check this fuse first, and replace if necessary.
Also check the power source to be sure that the proper
voltage is being provided to the heater.
Figure 5.
Control Panel
TO STOP THE HEATER
Simply turn the Power switch to “OFF” position and unplug
the Power Cord.
TO RESTART THE HEATER
1.Wait ten seconds after shutting off heater.
2. Turn the Power Switch
to “ON” position.
3. Be sure to follow all starting procedure precautions.
LONG TERM STORAGE
Drain Fuel Tank
1
、
put the heater on the working table and place an oil
container under the fuel tank
；
2
、
use a spanner to loose the drain screw und release the
water and waste inside the tank
；
3
、
after draining tighten the drain screw again and wipe
clean the left water and oil.
IMPORTANT: Never store leftover kerosene over the
summer. Using old fuel can damage your heater.
Store heater in a dry, well-ventilated area
Be sure that the storage area is free of dust and corrosive
vapors. Repack the heater in the original shipping material.
Keep the Users Manual in an easily accessible place.
Use only original equipment replacement parts. The use of
alternate or third party components can cause unsafe
operating conditions, and will void your warranty.
We suggest following a maintenance schedule as follows:
FUEL/FUEL TANK:
Flush every 200 hours of operation or as needed. Do not use
water to flush the tank. Use fresh 1-K kerosene only.
AIR FILTERS:
The Air Intake Filter should be replaced or washed with soap
and water and dried thoroughly every 500 hours of
operation, or less, depending on conditions.
The
Output and Lint Filters should be replaced every 500
hours of operation or less, depending on conditions.
NOTE: Use of diesel may require additional maintenance.
Figure 6. Filter Replacement
FAN BLADES:
Blades should be cleaned at least once per heating season,
depending on conditions.
Remove all accumulated dust and dirt with a damp cloth,
taking care not to bend any of the fan blades. Be sure fan
blades are restarting the heater. For Fan removal,
see
Figure 7 .
Figure 7. Fan Replacement
Never service heater while it is
plugged in or while hot!