EN
tightening, folding or loops which could obstruct gas flow. Before use, always check if hose is not cut, broken or
excessively worn out.
- Except connection spot, any part of the hose shall touch a hot part of the grill. If hose is visibly damaged, replace
it with hose suitable for use and conforming to the valid regulations.
- Hose shall not be longer than 1.5 m.
Note:
date on the hose is the date of manufacturing, not best-before date
LEAK TESTING:
- Leak testing shall be performed in well ventilated premises.
- Check that the ON / OFF switch is in the position "0". Open the gas valve on cylinder and check for leaks by
applying solution made of 1/2 water and 1/2 soap on all connections of the gas system.
-
NEVER PERFORM LEAK TEST WITH AN OPEN FLAME.
- If soap bubbles appear, there is gas leak. Turn off gas supply and tighten all fittings and repeat the test.
- If soap bubbles appear again, do not use the heater. Ask the authorized service for help.
- Perform leak test every year and always during disassembly or replacement of gas cylinder.
SWITCH ON:
- Connect the heater to a power source
- Set ON / OFF switch to position „I“.
- Wait until the fan blades are moving steady. Press the gas
control valve on the heater with your right hand and then
repeatedly press with your left hand the igniter until the flame
burns up.
- Hold the gas control valve pressed for another 10 seconds
then release, the flame to remain burning. If the flame goes out
after releasing the gas control valve, wait one minute and
repeat the ignition procedure except that the gas control valve will be held down for longer.
- Turn the adjustable valve for setting the flame intensity.
- After igniting the heater, check the flame, the normal flame is blue and does not come out of the front cover,
the flame on the ignition head is stable and the whole circle is the same shape. On the other hand, appliance is
damaged.
NOTE:
If you worked with the heater as described above and the appliance does not operate properly after three
attempts to turn it on, do not turn on the appliance again. There is a risk of explosion. Contact your dealer or an
authorized service center to find out and correct removal a malfunction.
SWITCH OFF:
- Close the gas control valve on the gas cylinder and let the heater run until the flame goes out. Set the ON / OFF
switch to the position "0".
USE AS A FAN:
- Remove the gas supply hose.
- Connect heater to a suitable electrical supply.
- Set ON / OFF switch to position „I“.
