Strend Pro 1E44F-5, Инструкция по эксплуатации

Страница: 43 / 51

or piping. If necessary, check the actual location of the electrical cables or piping by excavating the trench or
using search engines, such as cable detector.
WARNING! Impact on a hard object in the ground, such as rocks or tree roots, can cause the auger to
suddenly stop or react to the movement of the auger, causing the operator to lose control of the machine or
be dropped to the ground and suffer serious occupational accidents. To avoid this, always hold the device
firmly in both hands.
WARNING! Excessive exposure to vibrations can cause circulation problems for people who are suffering
from it and can also cause nerve damage. If you experience symptoms of excessive vibration exposure
(tingling, loss of feeling, tremors, pricking, pain, loss of fingers or wrists, discoloration and skin condition)
contact your doctor.
- Always ensure that you have a safe and stable
working posture.
- Always hold the tool with both hands.
- To auger smoothly into the ground, start drilling at
half throttle and gradually increase the engine
speed.
- If the auger bit is stuck in the ground and cannot
be pulled out, stop the engine and turn the machine
counterclockwise.
- Always switch off the engine after drilling.
- Keep hands and feet away from the drill until the
engine has come to a complete standstill.
- If a foreign object hits the tool or if you feel
vibrations, stop the tool immediately and check it
for damage.
MAINTENANCE
- Proper maintenance is essential to maintain the original efficiency and operational safety of the tool.
- Wear safety work gloves.
- Do not perform service work unless you have the necessary knowledge and equipment.
- WARNING! Turn off the tool, disconnect the spark plug wire and wait until the engine has cooled down
completely before performing any inspection or maintenance.
- Thoroughly clean the tool from dust and repair and replace any damaged parts after each operation.
- Store the tool in a dry place protected from the weather.
- Keep the air vents clean at all times to avoid overheating and engine damage.
- Never clean or spray water on the tool. Clean the engine cover with a soft, damp cloth. Never use cleaning
agents or solvents or solvents such as benzine, alcohol, ammonia, etc.! These solvents can damage the plastic
parts of the product.
- The starter cord should be replaced at the first signs of wear.
- Regularly check that all screws and nuts are tight.
CARBURATOR SETTINGS
- The petrol auger has been designed to minimize the amount of harmful emissions emitted.
- The carburetor regulates engine power. The carburetor mixes air and fuel. Correct adjustment of the air /
fuel ratio is important for the machine to function properly.
Idle adjustment
- Check that the air filter is clean.