Stratford EcoBoiler BK068, Руководство по эксплуатации и установке, Страница: 35 / 44

SOLID FUEL BURNING
•
Set the grate to the ‘+’ position
•
Ensure that the ash pan is in position and
the fire door is closed
•
Set the airwash to one quarter open and the
thermostat knob to position 5
•
Light in the normal way with kindling and or a
fire lighter
•
If you use a gas poker be sure to remove it
as soon as the fire is alight
•
When the fire is well alight regulate the burn-
ing rate by adjusting the thermostat control
knob
•
The air wash can be adjusted to keep the
glass clear.
ANTHRACITE
Anthracite can be a little difficult to keep in for
long periods, consequently care in setting the
controls, and some familiarisation is necessary
when burning anthracite.
Use small size fuels (Stovesse or Small Nuts).
Proceed as for any manufactured smokeless fuel.
Leave the Airwash air inlet control open about a
quarter or less.
See page 34 of this manual for a full list of
recommended fuel types, or visit the
HETAS web
site, www.hetas.co.uk
Note:
The high temperature paint acquires durabil-
ity by being ‘cured’ during the initial firings.
The appliance will give off fumes which are
non-toxic but which certain people find have
an unpleasant or irritant effect.
Ensure the area is well ventilated during this
time
.
Stratford EcoBoiler Stove 35
OPERATING INSTRUCTIONS
Longer Burning Periods
The appliance will burn for long periods at a re-
duced output rate provided:-
•
Sufficient fuel is placed in the firebox
•
The controls are set correctly
•
Excessive draught is not present in the
chimney
•
The Fire door is closed
•
If the fire goes out with some un-burnt fuel
remaining in the firebox increase the
thermostat setting and vice versa
Returning to a higher burning rate.
Open the air control fully until embers begin to glow
brightly and place pieces of fuel on the fire until it is
well established.
Note:
To avoid chimney problems your stove should
not be burnt slowly for longer than 12 hours
without a period of fast burning, 15 -20 mins.
.
WARNING:
Properly installed, with a suitable flue and
chimney, and operated and maintained this
appliance will not emit fumes into the dwelling.
Occasional fumes from de-ashing and refuelling
may occur. However, persistent fume emission
is potentially dangerous and must be
investigated by a HETAS registered engineer.
Stop using the appliance if you small fumes or
see smoke escaping
If fume emission does persist the following
immediate actions should be taken:-
•
Open all doors and windows
•
Let the fire die or extinguish it, and safely
dispose of the fuel from the appliance.
•
Check the flue for blockage, and clean if
required
Seek expert advice from your HETAS registered
engineer. Do not attempt to re-light the stove until
the cause of the fume emission has been identified
and corrected. See page 15 for details.