Stratford EcoBoiler BK068, Руководство по эксплуатации и установке, Страница: 12 / 44

12 Stratford EcoBoiler Stove
INSTALLATION
Fastening The Stove Canopy
Rear Flue Fitting
Before fitting the canopy ensure the stove top
insulation is seated correctly in the recess, see
fig. A, and if rear flue spigot connection is to be
used, fit the top hot plate.
Fig. A
Fasten the canopy onto the boiler body using the 2
off M6 wing nuts located on the top back face of
the boiler. The fixing method is the same for all 3
canopy styles, (Roll Top style shown), see fig. B
Fig. B
For rear flue operation fit the top flue blanking plate
as shown. The Slab top and Roll top canopy
blanking plates drop in place and requires no
fixings, see fig. C, The raised top canopy is held in
place by 2 off M6 wing nuts located on the under-
side of the blanking plate, see fig. D
Fig. C
Fig. D
Slab & Roll Top Blanking Plate
Raised Top Blanking Plate
Fastening the Canopy
Fitting the blanking plate
Please Note:
For the Slab top and Roll top canopy
the round blanking plate sits just slightly raised
from the canopy top face, the Raised top canopy
blanking plate sits flush into the recess formed in
the top surface.
Do not over tighten the wing nuts on the Raised
top blanking plate, they should be finger tight only
Warning:
The stove cannot be lifted by
the canopy once fitted.