8
Ensure the door is square. Check the diagonal measurements from corner
to corner of the door (dashed lines, Figure 3.7). The diagonal measurements
should be equal for the door to be square.
Ensure the lip of the Top and Bottom Door Channels fit over the Vertical
Door Channels (Figure 3.5).
Fasten the Handle Mounts through the pilot holes in the Vertical Door
Channel with two 10x16 wafer screws (Figure 3.3).
Handle Mounts
Vertical Door Channel
Figure 3.2
Fit the two Handle Mounts into the Vertical Door Channel (Figure 3.2).
The two Handle Mounts are the same component, so can be installed in
either order.
Door Nut
Top Door Channel
Door Wheel
Figure 3.1
Fix the Door Wheels to the Top Door Channel using Door Nuts (Figure 3.1).
10x16 wafer screws
Figure 3.3
Vertical Door Channel
Bottom Door Channel
Top Door Channel
Sheet Layout
Wall Sheet
Split Door Sheet
Figure 3.4
10x16 wafer screws
Figure 3.6
Figure 3.5
Top / Bottom
Door Channel
Vertical
Door Channel
Figure 3.7
10x16 wafer screws
Figure 3.8
Lay out sheets onto trestles/ blocks. Refer to figure 1.5 for lapping details. Fit
the Vertical Door Channels over the side of the door sheets, then fit the
Top and Bottom Door Channels over the door sheet ends.
Set the door in the square position by fastening two 10x16 wafer screws
through the pilot holes on the underside of each corner. (Figure 3.8).
Fasten one 10x16 wafer screw through the pilot holes in the corner of each
Top & Bottom Channel (Figure 3.6).