Guide Ramp
Channel
Guide Ramp
Door Guide Ramp
Plain Rivets
Sliding Door
Sliding Door
Sliding Door Mount
Roof Flashing
Roof Flashing
Lapping groove
Colour
Screws
Rear Roof Beam
Plain Rivets
Rear Wall Channel
Rear Roof Beam
Roof Fixing Detail
Colour Screws
Colour Screw
Place the door guide ramp over the door guide ramp channel as
shown in the detail below, and fix through the back edge of the
two components using four plain rivets (Figure 10).
Figure 10
Mount the sliding doors by inserting the slide rail on the back
of the door into the slide mechanism on the sliding door mount
(Figure11). A second person may be needed to help with this part
of the installation.
Figure 11
attaching the doors
Fixing the rooF
Fix the roof flashing onto the roof sheet with four evenly spaced
colour screws on the end of the sheet that does not have the
groove for lapping the sheets (Figure 12).
Figure 12
Fix the rear roof beam onto the rear wall channel with four evenly
spaced plain rivets (Figure 13).
Next, fix the roof sheet through the side wall channels using four
colour screws at each end of the sheet (Figure 14). Use the rear roof
beam to assist you in locating the correct placement of the roof
sheet, as shown in the Roof Fixing Detail.
Figure 13
Figure 14