Balco WaterJet
Cleaning Models
21
Spray Nozzle
Use the spray nozzle for cleaning—
• delicate parts
• parts with thin walls or fragile areas
• models made from TangoPlus, TangoBlack and TangoGray materials
Examples of models suitable for cleaning with the spray nozzle are: jewelry and dental appliances.
Caution:
Lack of water or insufficient water pressure can cause the pump to operate improperly,
overheat, or fail.
•
Always
open the water supply source
before
activating the WaterJet. The water
supply must remain open while the WaterJet is being used.
• Ensure that the water supply to the water pressure pump provides the required
pressure. (A typical water pressure pump requires a supply pressure of at least 2
bar.)
Operating the WaterJet
To operate the WaterJet:
1. Turn on the main power switch on the front panel of the WaterJet (see
).
2. Open the WaterJet cabinet side door.
3. Place a model in the WaterJet cabinet.
4. Close the side door.
Note:
Do not continue until you make sure that you closed the side door.
5. Insert your hands in the built-in gloves.
6. Select a suitable cleaning nozzle (see
).
7. Make sure you grasp the nozzle before you activate the WaterJet.
8. Activate the WaterJet using the foot pedal (see
) and clean the model.
Note:
For optimum results, press the foot pedal down completely and continuously.
9. When you have finished removing the support material, open the side door and remove the model.
10. If there are no more models to be cleaned at this time, switch off the WaterJet.
11. Turn off the water supply to the WaterJet.
