Strand 200 Console Manual
Page 23
Effects Playback
Each recorded effect will display the
yellow LED above it. To run an effect,
press the effect button that is
requested. The yellow LED above it will
begin flashing. Then press the “Go/stop”
button to start the effect(s). The lower
LED’s will now go off and the upper LED
(red) will be on indicating the effect is
running.
To stop an effect, press the corresponding effect key again. (Remember
to select the correct page first), the yellow LED will be
flashing.
T
hen press
“Go/Stop” key again, the selected effect will stop (both red and yellow
LED will turn off).
Additional Information for Effects Playback
•
To change the effect mode, direction and step rate for any particular effect while it is
running, select the effect itself followed by the wanted mode, direction and step time,
the effect will immediately change to the new mode and direction. Press effect key
again to exit from change. The effect now will run on the new setting. (note: the
recorded setting will not change).
•
During effect playback, the red LED for the running effect(s) will be flashing when the
effect(s) is on the current selected page, to provide the operator easy visual
reference, which effect(s) on which page is actually active.
•
The following combinations will be allowed:
o
Chase (Random or forward or reverse or bounce or audio)
o
Build (forward or reverse or bounce)
o
Cycle (forward or reverse or bounce)
Note: See Audio section of Setup to properly configure the console to have an audio source trigger an
effect.
•
To step an effect from an audio source, set your effect to chase/audio. (See
instructions for above ). Select the effect as normal (select effect key and press
go/stop button), it will step thru that effect when audio signals within that frequency
range is fed in. Deactivate the effect as usual (select effect key and press go/stop
button).
