INSTALLATION
CHOOSING YOUR INSTALLATION
Make sure that the air inlets through the
ventilator grids underneath the hob are
never blocked.
We recommend that you install this ap-
pliance in a work top which is a minimum
38mm deep.
The hob can be fitted into a work top
less than 38mm deep, but the 20mm gap
between hob base and appliance must be
maintained.
Installation above an oven
Refer to the manufacturer’s instructions
for clearances above the oven.
We recommend a 20mm gap between
the bottom of the hob and appliance.
An air outlet of 5mm underneath work
surface is required.
Installation above a unit with a
drawer or door
An air outlet of 5mm underneath work
surface is required. If necessary, remove
the front crosspiece of the unit.
The base of the appliance must be pro-
tected from damage e.g. draws may only
be installed providing a partition panel is
fitted to the required dimensions under
-
neath the appliance. Suitable protection to
prevent obstruction of the air inlet to the
fans must be provided.
In the case of a pyrolytic oven
If installing the hob above a pyrolytic
oven, additional provision for air circula-
tion / ventilation may be required.
Due to the excessive temperatures at-
tained during pyrolysis, using the hob at
the same time may cause the thermal
safety device within the hob to operate.
Worktop
Min 20mm
Oven
Hob
INSTALLATION ABOVE AN OVEN
Worktop
Min 20mm
Partician
Hob
Partition
INSTALLATION ABOVE A UNIT WITH
A DRAWER OR DOOR
Min 5mm
Min 5mm