Storno CQM6113, Руководство пользователя, Страница: 3 / 14

The scan sub-mode:

The scan sub-mode is entered/left by pressing the S key and is working in modes 0 and 3 .

The scan sub-mode has its own indicator - LED "Scanning indicator". In the scan sub-mode, the
keys "Volume up" and "Volume down" are used to increase/decrease the number of the current
channel (mode
0 ) or frequency (mode 3 ).
In the scan sub-mode, the A key starts/stops the automatic channel scan (mode 0 ) or scan in the
frequency interval (mode 3 ). The Scan indicator will flash, pointing to the automatic scanning.
Before starting the automatic scan, be sure that you have set the starting and ending channels or the
starting and ending frequency.
If the starting and ending channels have been set before, setting them again is not necessary - when you
turn off the radio starting and ending channels are stored in memory.
Each array of the channels has the ability to set their own the starting and ending channel for a scan.
Channel scan: Upon detection of activity at a channel during the automatic channel scan, the program
holds for a 10 seconds (maximum), giving the opportunity to make a decision about the channel.
Frequency scan: when scanning frequencies, the delay is set to 5 seconds. If the frequency scan will be
interrupted, the current frequency will be taken for a new beginning or the new ending of the scan (if the
current frequency will be higher then the ending frequency after setting).
The Selective Call mode: (work in mode 0)
The main purpose of ‘Selective Call’ is to open squelch only when receiving the correct ID number. When
this occurs, the "Car horn" key will be open for 1 second. The channel will be closed at the end of the
carrier.
Selective Call mode is switched on/off by pressing the Bell (‘External alarm on/off’) and has its own
indicator – LED: Bell (External alarm). This option works fine on radio with old type of control board with
main DIP chips and bad on the radio with new type of control board with main SMD chips. Probably the
new DSP firmware OKI M77C20A are slightly different from the old one.
To configure this mode:
1.
When Selective Call mode is OFF, click the " Mode selector " and then press key Bell (this state
holds for 5 seconds without pressing any key).
You will see a string, for example: "12345 CCIR", where: "12345" - is the Selective Call ID
number of your radio. You can change it by typing a new number from the keyboard.
‘CCIR’ - is codec name. Type of the codec is selected by successive pressing of the
Bell key.
Keys used in this mode:
0-9 For typing the ID number.
Bell To select the codec.
Queue To exit from this mode.
CL To backspace in editing.
2.
When in the Selective Call mode, click the ‘ Mode selector’ then press the key ‘ Bell’ (this state is
set on 5 seconds without pressing any key).
You will see the next string, for example:

1 12345 +12ABC , where:

is the tone-coded
squelch flag. When it is ON -

is set, your sound channel will be open only after getting right ID
number! This flag is switched by pressing Call Transmitter key - tone key and works only in
Selective Call mode.