54
Initial operation
A
Temperature controller, 16
levels
B
Trigger
C
Battery lock
D
Battery
E
Blade holder
Warning:
Set the temperature controller to medium position and place the blade on
the edge of the material you will be cutting. Press the lever and move the
blade through the material. Optimum cutting is virtually smoke free.
Note:
For best possible results, perform a couple of trial cuts in remnants of the
material you will be cutting.
When working with the HotKnife 36 V, it is advisable to adjust the tempera-
ture to match the cutting speed.
If smoke develops during cutting, the cut is either being performed too slowly,
or the blade temperature is too hot. This can lead to uneven and wide cuts. To
avoid this, reduce the temperature of the blade via the temperature controller,
or adjust the trigger actuation accordingly.
If the resistance increases during cutting, press the trigger again, or adjust the
temperature via the temperature control. This approach will extend the service
A
C
D
B
E
A
Original instruction
