STONEFLY ISC-1208s, Руководство по установке

Страница: 37 / 58

StoneFly ISC Setup Guide Initial Installation
V8.0.3x © StoneFly Inc. | All rights reserved Page 36
2. Follow the screen prompts to accept the certificate. The number of screens will vary
depending on which browser you are using. When the security certificate is accepted, the
ISC
administrative interface login screen will appear.
3. Click System and then Network to confirm the network settings.
4. Click
Data Port
and confirm the settings.
5. Click Management Port and confirm the settings.
6. Click Routing and confirm the settings.
3.1.9 Steps to Complete Before Setting Up the System:
3.2 Read the Release Notes thoroughly. These can be found in your documentation CD.
3.3 Verify that your Host Initiators are at the most current revision levels. For example, if
you are using the Microsoft Windows iSCSI Initiator, obtain the latest version from
Microsoft.
3.4 Refer to Appendix 7: System Considerations in the Storage Concentrator User’s Guide
and make sure that you set up your servers according to the instructions in that section
before connecting or using your StoneFly ISC Appliance.
CAUTION: Not setting up your systems according to those instructions will cause
timeouts and SAN disconnections.
3.1.11 Attaching and Removing the Front Bezel
Follow the below steps when attaching or removing the front bezel of the StoneFly ISC:
• Attach the front bezel after initial installation is completed. This will help prevent
damage to the drives during everyday use. The cover snaps on and off easily and can be
removed as needed.
•
To install the cover, gently press to snap the cover into place.
•
To remove the cover, gently pull the cover towards you to remove it from the front panel.
The browser will display an alert regarding the security certificate for
the site. This occurs because the IP address for the ISC was changed
from the factory default to one appropriate for your network.
If the administrative interface login screen does not appear, repeat the
steps listed in “Configuring the Network Settings” on page 19.