Stone RP850D, Руководство оператора

Страница: 23 / 36

- 23 -
OPERATION
RP850G / RP850D
OPERATING THE ENGINE (Hatz)
Starting the engine
1. Adjust engine speed control lever (1) to full
load “II”.
2. Slowly pull out handle 93) with rope, until
detectable resistance can be felt.
3. Allow the rope to run back in to enable you to
utilize the whole length of rope for the starting
procedure.
4. Take hold of the handle (3) with both hands.
5. Pull the starting rope with increasing speed
until the motor starts up.
6. Allow the engine to warm up for 1 to 2 minutes
when idling.
Important: If the motor does not ignite after several
unsuccessful attempts at starting, move the speed
control lever back into the stop position and pull the
starting rope through slowly, 5 times. Then repeat the
starting procedure.
Switching off the engine
1. Adjust engine speed control lever to idle
position (I).
2. Press motor stop button (4) until the motor
stops running.
3. Release the stop button (stop button must
return to its initial position).
Electric start (Hatz only)
1. Adjust engine speed control lever to full load.
2. Insert the ignition key (1) and turn to “I”,
charging indicator lamp (4) and oil pressure
lamp (5) must light.
3. Turn ignition key “II”. As soon as the engine
starts, release the ignition key.
Attention:
- The ignition key must spring back to position
“II” automatically and must remain in this
position during operation.
- The charging and oil pressure indicator lamps
must extinguish directly after each start.
- Before each new start, turn the ignition key
back to “0”.
- Indicator lamp (3) lights to show that the
engine is operating.
Switching off the engine
1. Adjust engine speed control lever to idle
position (I).
2. Press motor stop button (4) until the motor
stops running.
3. Release the stop button (stop button must
return to its initial position).
4. Charging indicator lamp and oil pressure
indicator lamp light.
5. Turn ignition key to “0” and remove.