51
MUD BUGGY
Maintenance
TRANSMISSION
The hydrostatic transmission is properly adjusted when no movement of the unit is visible
when controls are released.
Transmission Return to Neutral Adjustment
The hydrostatic transmission is equipped with a self-centering device that centers the
swash plate to stop flow to the wheel motors, stopping the machine. If unit creeps one
direction when controls are released adjustment may be required. To adjust use the follow-
ing procedure:
1. Follow procedure in the Operation Section of this manual to Shut Off Machine.
2. Detach throttle control cables at transmission and jack front wheels off of ground.
3. Start machine. Increase engine throttle to full speed while checking for front drive
wheel rotation. If wheels rotate proceed to Step 4. If no rotation is observed shut
off machine and reattach control cables.
4. Note the directional movement of the front drive wheels. SHUT OFF MACHINE.
Loosen the lock down screw until the return arm can be rotated. If wheels were
observed moving forwardrotate return arm clockwise. If wheels were observed
moving in reverserotate counterclockwise. Tighten lock down screw and follow
step 3.
POTENTIAL FOR SERIOUS INJURY. CERTAIN PROCEDURES REQUIRE THE MACHINE TO BE
OPERATED WHILE RAISED OFF OF GROUND. TO PREVENT INJURY, ENSURE THE MACHINE
IS PROPERLY SECURED.
DO NOT ATTEMPT any adjustments with the engine running. Use Extreme CAUTION while
inspecting all vehicle linkage.
HOSES, FITTINGS AND LEAKAGE
Check weekly for loose hose fittings, damage, and leakage--it is important to check entire
machine periodically.
BRAKE ADJUSTMENTS
Brakes are adjusted at factory and will need to be adjusted as brake shoes wear. Check
operation daily. Adjust at 25 hours then as needed.
SERVICE BRAKE ADJUSTMENT
Brake adjustment rods need adjusting in equal amounts. Jack machine up so that front tire
is off ground. Remove clevis pin from yoke. While screwing yoke, keep count of number of
turns for repeating the same procedure on other side until brake is adjusted.
Parking Brake Adjustment--Turning the knob on the parking brake handle clockwise will
adjust the parking brakes.
WARNING
Содержание Mud Buggy FB1000
