Stone HM1290, Руководство оператора

Страница: 15 / 20

- 15 -
Lubrication
Caution - Set mixer up in an open area.
Avoid close proximity to structures or other
equipment. Failure to do so may cause
inadvertent injury to operator or other
persons in the area.
Cold Start - Open the fuel valve under the gas
tank all the way. Position the engine stop
switch, located on the engine, to run. Open the
throttle approximately half way and apply the
choke. Pull the starter rope sharply. When the
engine starts, open the choke and adjust the
throttle as necessary to keep it running. Allow
the engine to warm up for a few minutes before
placing it under the load. If the engine doesn't
start after (3) pulls, open choke slightly to
prevent flooding. Always operate the engine at
full throttle when under load.
Hot Start - Open the valve under the gas tank
all the way if it has been shut off. Open the
throttle approximately half way. Do not apply
the choke. Pull the starter rope sharply until the
engine starts. When the engine starts, adjust the
throttle. Always operate the engine at full
throttle when under load.
NOTE: These starting instructions are general
guidelines only. Since many engine options are
available on Stone PM mixers, consult the
Engine Manual included with this unit for
specific instructions.
To Start and Stop the Engine
Caution - Gasoline Engines - To improve the
engine service life, allow the engine to idle
without load for (2) to (5) minutes before
shutting it down. When the idling period is up,
use the stop switch located on the engine and
turn it to stop. Close the fuel valve under the
gas tank. Engine flooding can occur if the valve
is left open during towing.
Warning - This mixer is designed for mixing
only mortar, plaster, fireproofing, refractory
and other small grained Portland cement
products. Any other use of this mixer may
cause premature failure and or great personal
risk to the operator or other individuals close
by. Do not use for mixing any volatile or
corrosive material.