- 17 -
Operation
Daily
1. Check the oil levels in the engine. If re-
quired, add a good grade of 10W30 oil. The
engine warranty is VOID if run without oil.
2. Check oil level in hydraulic tank. Oil should
be visible in the sight gauge. If required, add
Mobil 424 or equivalent.
Do not overfill.
Weekly
1. Grease, using any Grade #1 lithium base
greas,. the drum shaft seals centrally located
on outside of each drum end (2 places).
Monthly
1. Grease, using any Grade #1 lithium base
grease, trunnions (sockets in which the drum
pivots) in two places.
Yearly
1. Have service/maintenance repack (4)-tapered
roller bearings in wheel hubs and replace
wheel seals. Install washer and nut.
Torque to 20 ft.lbs.--back off one turn, torque
to 7 ft.lbs, back off to first slot in nut and
insert cotter key.
Cleaning the Mixer
To Lubricate the Mixer
Cleaning the Mixer
- For consistent perfor-
mance, long life and continued high quality
mixing of plaster or mortar, thoroughly clean the
mixer inside and out at the end of each days
operation. To prevent lumps of dried plaster
from forming and contaminating further batches
of plaster or mortar, do not allow build up
materials to form on drum guards, around
paddles or anywhere inside the drum.
Before cleaning, shut the engine off and
disconnect the spark plug wire/power to
electric motor to prevent accidental starting.
Keep drum guard closed
Always keep guard lifter connected
Keep drum in upright, mixing position
Spray mixer with water before mix dries to
remove accumulation
Rotate drum to dump position to remove
debris
DO NOT beat on the drum with a shovel,
hammer or other device to break up accu-
mulations of dried mix, as this will dent and
damage the drum and void the warranty.
FAILURE TO FOLLOW CLEANING
INSTRUCTIONS AND/OR ROTATION OF
DRUM WITHOUT GUARD LIFTER CON-
NECTED CAN RESULT IN SERIOUS
INJURY.
WARNING
Содержание HM1290
Страница 2: ......
Страница 8: ...8 Technical Data Operator Controls...
Страница 9: ...9 Technical Data Decal Identification...
Страница 18: ......