Stone CHAMPION 855PMP, Руководство оператора

Страница: 15 / 24

- 15 -
OPERATION
OPERATING FEATURES
Your new 855 plastic drum plaster/mortar mixer
comes standard with the following features:
PATENTED AUTOMATIC GUARD LIFTER
Lifts the drum guard as the drum is tilted to prevent
the mix from being poured through the guard and
causing a building up on it. The guard and guard
lifter system is designed for your safety and
convenience, please DO NOT operate the mixer
with the guard lifter disconnected or the guards
removed.
QUADRUPLE SHAFT SEAL
Provides a life long neoprene and urethane seal
system that completely isolates the sealed ball
bearings in the drum trunnions from the mix.
EXTENDIBLE AXLE
Collapses to less than 36 inches total width for ease
in maneuvering mixer around the work site or to
save space while the mixer is in storage, extends to
46 inches total width to provide stability and safety
when towing the mixer.
BEFORE STARTING
READ ENGINE OWNERS MANUAL.
Mixers are shipped completely assembled and ready
for operation except for installation of the safety
chain.
SAFETY CHAIN INSTALLATION
Remove the safety chain kit from the engine
compartment. The kit includes (1) 12 ft. length of
safety chain and (2) connecting links. Pull one end
of the chain through the (2) key hole slots located in
the front post of the mixer with a hook (see drawing
below and decal on mixer front post). Attach the
connecting links to each end of the chain. Follow
the instructions in the TOWING section of this
manual and on the mixer front post to attach the
safety chain to the towing vehicle.
INSTALLING CHAIN TO MIXER
DUMP HANDLE INSTALLATION
Remove the dump handle from the mixer drum
where it is attached to the paddle shaft. Consult the
FRAME AND DRUM ASSEMBLY section of this
manual and use the (2) 3/8 bolts and nuts provided
near the top, tow pole end of the drum to install the
drum handle as shown in the exploded view. Do not
torque bolt that holds the guard - see note in the
TORQUE CHART section of this manual.
OIL LEVELS AND LUBRICATION
Be sure to check the oil levels in the engine and
engine reduction unit BEFORE starting this unit.
The engine warranty is VOID if it is run without oil.
Consult the ENGINE MANUAL supplied with this
unit for specific instructions and oil
recommendations.
AXLE BLOCKS (SPRING AXLE OPTION
ONLY)
Before your mixer was shipped, wood blocks were
placed in the axle springs to avoid bouncing during
transport. Before operation, loosen spring bolts,
remove blocks and retighten spring bolts until
locknut is fully engaged.
Operating FeaturesLocation
and Use of Controls