10
866-795-1586 • WWW.STONEAGETOOLS.COM
1. Mount the appropriate frame
Positioner Clamps
to the tube
bundle as shown on the previous page. (Shown in Figure 1 with
Slotted Quick Clamps) Positioner Clamps should be aligned
horizontally with the direction of the tube rows.
(Figure 1)
NOTE: Heat exchanger tube bundle face, shown for graphic
representation only. Not included in assembly.
2. Insert the
Top Rail (slots facing out)
into the upper mounting
brackets. If the rail is not closely aligned with the tube rows,
loosen one of the upper mounting brackets and adjust until
the top rail is parallel with the horizontal tube rows. Tighten the
clamps securing the rail to the mounting brackets. Ensure upper
mounting brackets are securely clamped or bolted to the tube
bundle flange.
(Figure 2)
3. Insert the
Lower Rail (non-slotted)
into the lower mounting
brackets. It is not critical that this rail is aligned as precisely as
the top rail, but it should be close to parallel with the top rail
for best performance. Tighten the clamps securing the rail to
the mounting brackets. Ensure lower mounting brackets are
securely clamped or bolted to the tube bundle flange.
(Figure 3)
4. Loosen the
Quick Adjust Handle
and pull the gearbox away
from the carriage plate. This will allow the
Horizontal Drive
Carriage
to slide onto the rail without pneumatic power, to
rotate the drive. Center the carriage on the top rail and push
the gearbox back toward the carriage plate. This will engage
the gear into the rail slots. Verify the gear is engaging the slots
correctly and tighten the quick adjust handle.
(Figure 4)
LIGHTWEIGHT POSITIONER STEP BY STEP SET-UP
LIGHTWEIGHT POSITIONER SET-UP
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
