Stoelting SO212, Руководство оператора

Страница: 10 / 30

4
2.2 SHIPMENT AND TRANSIT
The freezer has been assembled, operated and inspected
at the factory. Upon arrival at the final destination, the
complete freezer must be checked for any damage which
may have occurred during transit.
With the method of packaging used, the freezer should
arrive in excellent condition. THE CARRIER IS RESPON-
SIBLE FOR ALL DAMAGE IN TRANSIT, WHETHER
VISIBLE OR CONCEALED. Do not pay the freight bill until
the freezer has been checked for damage. Have the
carrier note any visible damage on the freight bill. If
concealed damage and/or shortage is found later, advise
the carrier within 10 days and request inspection. The
customer must place claim for damages and/or shortages
in shipment with the carrier. Stoelting, Inc. cannot make
any claims against the carrier.
2.3 FREEZER INSTALLATION
Installation of the freezer involves moving the freezer
close to its permanent location, removing all crating,
setting in place, assembling parts, and cleaning.
A. Uncrate the freezer.
B. Accurate leveling is necessary for correct drainage
of freezer barrel and to insure correct overrun.
Place a level on top of the freezer at each corner
to check for level condition. If adjustment is
necessary, level the freezer by turning the caster
in or out and tighten the locknut. (Fig 2-2).
C. The freezer is equipped with an air cooled
condenser and requires correct ventilation. The
front of the freezer is the air intake and the back
discharge. Both front and back must have a
minimum of 3" of clearance. (Fig 2-3).
CAUTION
Failure to provide adequate ventilation will void war-
ranty.
D. Place the OFF-ON switch in the OFF position.
E. Connect the power cord. The plug is designed for
208 or 230 volt/20 amp duty. Check the nameplate
on your freezer for proper supply. The unit must
be connected to a properly grounded receptacle.
The electrical cord furnished as part of the freezer
has a three prong grounding type plug (Fig. 2-4).
The use of an extension cord is not recommended,
if necessary use one with a size 12 gauge or
heavier with ground wire. Do not use an adapter
to get around grounding requirement.
CAUTION
Do not alter or deform the plug in any way.
F. Install the drip tray, drain tray, hopper cover and
other miscellaneous parts on the freezer.
Figure 2-2 Leveling
Figure 2-3 Space and Ventilation Requirements
Figure 2-4 Electrical Plug