STOCK-ade C10066, Инструкция по эксплуатации и запасным частям

Страница: 18 / 29

18
Note: Troubleshooting problems may have similar causes and solutions.
TROUBLESHOOTING CHART
PROBLEM POSSIBLE CAUSE SOLUTION
Low discharge pressure Tank petcock is open Close petcock
Fittings Leak Check fittings with soapy water. Tighten or reseal leaking fittings.
DO NOT OVERTIGHTEN.
Restricted air intake Clean or replace air filter element.
Restricted check valve Remove and clean or replace.
Hole in air hose Check and replace if necessary
Tank leaks Immediately replace tank. DO NOT attempt to repair.
Blown seals Replace any faulty seals
Valve leaks Replace worn parts and reassemble with new seals.
Leaking or worn piston seal Replace piston and cylinder sleeve assemblies.
Excessive unloader
cycling Fittings leak Check fittings with soapy water. Tighten or reseal leaking fittings.
DO NOT OVERTIGHTEN.
Air leaks from regulator,
or regulator does not
regulate pressure Dirty or damaged regulator
internal parts. Clean or replace regulator or internal parts.
Regulated pressure
gauge reading drops
when air accessory is
being used. This is normal If pressure drops too low, adjust regulator while accessory is
used.
Compressor not large enough
Check air requirement of accessory. If it is higher than CFM and
pressure supplied by compressor, you need a larger compressor.
Most accessories are rated at a 25% duty cycle.
Compressor won’t start
in cold temperatures Engine flooded Remove spark plug and dry it. Reinstall.
Compressor too cold Move compressor to a warmer location.
Overheating Poor ventilation Relocate compressor to an area with cool, dry and well-circulated
air.
Dirty cooling surfaces Clean all cooling surfaces of pump and engine thoroughly.
Leaking valve Replace worn parts and reassemble with new seals.