Managing various targets on the same PC
AN4989
110/118
AN4989 Rev 3
Figure 85. Getting target ST-LINK S/N from the console
The next sections detail the selection of a specific target with each of the main IDEs
considered in this application note.
IAR™ EWARM
The first time a debug session is launched while several targets are connected, a Debug
Probe Selection window pops up.
A list of connected targets is displayed, identified by the last four bytes of the ST-LINK S/N
as illustrated in
.
Figure 86. IAR™ EWARM Debug Probe Selection pop-up window
It is recommended to use the Edit Nickname feature to ease board identification in
anticipation of further connection as shown in
.
Содержание STM32 Series
Страница 46: ...Connecting to the board AN4989 46 118 AN4989 Rev 3 Figure 30 Keil hotplug step2 ...
Страница 91: ...AN4989 Rev 3 91 118 AN4989 Debug through hardware exploration 117 Figure 69 STM32F4 F7 dual MCO capabilities ...
Страница 103: ...AN4989 Rev 3 103 118 AN4989 Managing DBGMCU registers 117 Figure 78 Generator Options debug MCU in STM32CubeIDE ...
