5
LRWAN_NS1 sensor device setup and reconfiguration
This section describes the steps to setup the LRWAN_NS1 sensor device and if necessary, reconfigure it to the
desired frequency band. By default, the device is configured for the CN470Prequel frequency band and in the
OTAA mode.
5.1
Sensor device setup
1.
Make sure that the USB drivers are installed. Download ST-LINK USB driver (
) from
Figure 20.
ST-LINK driver installation
Run the batch file to install
2.
On the LoRa
®
expansion board, connect the antenna to connector CN10 (for
).
Figure 21.
Antenna and personal computer connection
CN1 connector
for the USB Mini-B cable
CN10 connector
for the antenna
3.
Connect the Nucleo board to a personal computer with a USB Type-A or USB Type-C
®
to Mini-B cable
through USB connector CN1 to the power the board. Then red LED LD3 (PWR) and LD1 (COM) light up.
UM2587
LRWAN_NS1 sensor device setup and reconfiguration
UM2587
-
Rev 3
page 25/55
