6
ASSEMBLY
Step One
Assemble the Stability Feet
(IA-1101) and the A-frame Base
(FS-1010)
Set the A-Frame so the base
points up (Figure 1). This will
give you downward leverage
to properly assemble the
Stability Feet. Steady both
sides of the A-frame so the
legs do not swing open.
• Determine which is the right
and left stability foot by the
imprinted letters “R” and
“L” on each foot. Place each
foot on the frame so that the
letters will face inward toward
each other (Figure 1A).
Once the Stability Feet are in
place, turn the A-frame over
so the Stability Feet are on the
ground. Open the A-frame and
make sure the spreader arms
are locked (Figure 2).
Figure 1A
Figure 1
Figure 2
spreader arms
front
back
L
11
ASSEMBLY
Step Six
Install the Rear Bar Assembly
• With the rounded corners
of the rear foam Heel Cup
facing down, insert the Rear
Bar with one Heel Cup
(IA-1113) into the large hole
at the bottom of the Main
Shaft (Figure 15).
• Insert the Bolt (IA-1116)
to secure the Rear Bar to
the Main Shaft, and attach
the washer and nut with
the wrenches (F5-1088)
provided (Figure 16).
• Slip the other Heel Cup
(rounded corners down) onto
the Rear Bar and push the
Rubber Plug (F5-1056) into
the Rear Bar (Figure 17).
Figure 15
Figure 16
Figure 17
t p
S
ne
S Y S T E M
T M
t p
S
ne
S Y S T E M
T M
