Stiroplus SP2010, Инструкция по эксплуатации

Страница: 16 / 20

15
4. When the temperature indicator turns off, the selected temperature is reached. You can
start ironing now.
WARNING: Never touch hot soleplate at any time before cooling down!
Steam ironing
The machine works with normal tap water. In case of very hard water (hardness above 27ºF) we suggest
using 50% distilled water diluted with tap water. Alternatively, we suggest using normal bottled drinking
water. The use of de-ionized water is not recommended.
1.Press the “Water tank release button” and grasp the water tank’s handle to remove the water tank, then
fill it with water through the filling aperture. After it, replace the water tank properly. The maximum
capacity of water tank is 1.8L, the water level shall not be exceeded the MAX mark.
2.Put the iron on the thermal insulation stand of unit base.
3.
Connect the plug to the wall outlet, press down the Power switch and the power indicator lights up, and
the defaulted ECO steam rate indicator will flash. And there are two modes including ECO and high steam
rate available, you can select the desired steam rate for each garment according to your requirement. Make
sure that there is enough water in the water tank.
4. Turn the temperature dial to your desired setting, which is depended on the fabric of garment, and the
temperature indicator will illuminate. The iron starts heating. Refer to “IRONING TIPS” and “ADDITIONAL
TABLE” as below when select temperature.
5. After a few minutes, the temperature indicator will extinguish, it indicates the soleplate temperature has
achieved the selected temperature, and the iron is ready for ironing garment with steam.
6.Press the steam trigger with a little force, the steam will be sprayed from the soleplate, and then you can
iron the garment with steam.
NOTE: There may be dripping water during spraying steam when the temperature is at
and lower than the second setting. This is normal.
CAUTION:
(1) Do not touch hot soleplate at any time before cooling down!
(2) Never direct the steam at people!
7. For hard creases, quickly press the steam trigger twice to produce shot of steam. An interval of at least
15 seconds must be maintained between two continuous cycles. The “Shot of steam” function can be only
activated under ECO and Ηigh steam rate.
8.After ironing, hold and press the Power switch for about 2 seconds, the appliance will be turned off and
all the indicators will extinguish. R
emove the plug from the wall socket. But the soleplate is still hot, never
touch it with hand, place it on the thermal insulation stand until it cools down completely.
CLEANING AND MAINTENANCE
Before cleaning, firstly disconnect the power outlet and let the appliance cool down.
Wipe flakes and any other deposits on the soleplate with a damp cloth or a non-abrasive (liquid) cleaner.
NOTE: Do not use chemical, steel, wooden or abrasive cleaners to scrape the soleplate.
Clean the upper part of iron with a soft damp cloth. Wipe the water drop on the unit base and the thermal
insulation stand with a dry cloth.
When do not use the appliance for a long time, empty the water in the tank, and put the iron on the
thermal insulation stand and then press the iron lock “ ” to lock the iron well.
NOTE: The whole steam station iron can be lifted up by grasping the iron’ s handle after the iron being
properly locked on the thermal insulation stand.