29
AFTER SALES SUPPORT
1300 886 649
AUS
MODEL: W60B2A411B PRODUCT CODE: 48538 08/2015
Instructions (Cont.)
Adjusting the rinse aid dose
The rinse aid dispenser has four settings. To adjust the dose, proceed as follows:
•
Turn the cap of the dispenser anticlockwise to remove (see Fig. 19, opposite).
•
Turn the arrow to the desired number. Always start with the dispenser set on “2”,
as illustrated (Fig. 22).
•
If spots and poor drying are a problem,
increase the amount of rinse aid
dispensed by rotating the dial to “3”. If the dishes still are not drying properly or
are showing spots, adjust the dial to “4”.
•
Reduce the dose if there are sticky whitish streaks on your dishes or a bluish film
on glassware or knife blades.
When to refill the rinse aid dispenser
Fill the rinse aid dispenser when the warning light on the control panel comes on
(unless you are using “3 in 1” or similar detergent tablets with rinse aid, in which case
you can ignore the warning light). Alternatively, you can estimate the amount of rinse
aid left in the dispenser by the colour of the optical level indicator, which is located
next to the cap (see Fig. 20, opposite). When the rinse aid container is full, the whole
indicator will be dark. As the rinse aid diminishes, the size of the dark dot decreases,
as indicated below. Never let the rinse aid level fall below 1/4 full.
Full
3/4 Full
1/2 Full
1/4 Full - refill now to prevent spotting.
Empty
Fig. 22
NOTE
If you are using detergent tablets that contain a rinse aid, you do not need to add
liquid rinse aid and can ignore the “Low Rinse” indicator light when it comes on.
