14
AFTER SALES SUPPORT
1300 886 649
AUS
MODEL: W60B2A411B PRODUCT CODE: 48538 08/2015
Installation (Cont.)
Connecting the water supply hose
Connect the water supply hose to your cold water supply with a threaded 3/4”
connector (Fig. 6). During use, the dishwasher will heat up the water to the required
temperature. Make sure the hose is not kinked or squashed and is fastened tightly. If
the water pipes are new or have not been used for an extended period of time, let the
water run to make sure it is clear and free of impurities. This step is necessary to avoid
the risk of the water inlet being blocked and damaging the appliance.
Tension adjustment of the door spring
After you have attached the front panel, try to open and close the door to check the
balance and ensure that the door can remain in the same place. If there are balance
problems, adjust the screw in clockwise or counterclockwise direction until the door is
properly balanced (Fig. 5).
Fig. 5
3
~
7kg
Hexnut tool
CR-V 4mm
30
°
~
90
°
balance
Fig. 6
Hot water connection
The appliance can also be connected to your
hot water supply as long as it does not exceed a
temperature of 60ºC. Connecting the appliance to
the hot water supply will shorten the wash cycle
time by about 15 minutes.