Stirling SVD7, Инструкция по эксплуатации

Страница: 8 / 15

15 14
MODEL: SVD7 | PRODUCT CODE: 701109 | 06/2020 MODEL: SVD7 | PRODUCT CODE: 701109 | 06/2020
13
AFTER SALES SUPPORT
1300 886 649
info@tempo.org
AUS MODEL: MDR70-VR031 PRODUCT CODE: 61494 06/2018
Installation (Cont.)
• Using a drill with a
∅
14mm drill bit, drill four holes for the expansion bolts
according to the drawing on the positioning paper (Fig. 4). The hole depth must be
60mm.
NOTE: If you are installing the appliance on a tiled wall, use a special
∅
14mm drill
bit for use on tiles (Fig. 5).
Fig. 4
Fig. 3-A Fig. 3-B
Fig. 5
Step 3: Wall preparation
• Determine the dryer position on the wall and, using a spirit level, draw a level line
the length of the positioning paper (Fig. 3-A).
NOTE: Ensure the screw holes are in an appropriate position: they must not overlap
with any power outlets, cabling or taps.
The bottom edge of the positioning paper must be at least 45cm+ above floor level.
• Remove the adhesive paper from the back of the position paper and paste the
paper horizontally to the wall (Fig. 3-B).
14
AFTER SALES SUPPORT
1300 886 649
info@tempo.org
AUS MODEL: MDR70-VR031 PRODUCT CODE: 61494 06/2018
Installation (Cont.)
Step 4: Bracket installation
• Attach the brackets to the wall using the four expansion bolts. The expansion bolts
consist of a bolt, an expansion tube, a nut and washers.
a. Insert a bolt and expansion tube into each of the four drilled holes and then
thread a nut onto the end of the bolts. To prevent the thread being damaged, do
not expose the end-thread of the bolt. Then hammer the four bolts into the holes
(Fig. 6).
Fig. 6
b. After you have hammered the bolts into the wall, remove the nut and washers.
Attach the hanging brackets to the bolts, then put the washers back on: first the
flat washer, then the spring washer, then the nut.
c. Tighten the brackets with a socket or a wrench (Fig. 7).
Fig. 7
Installation (Cont.) Installation (Cont.)