13
12
MODEL: SVD7 | PRODUCT CODE: 701109 | 06/2020
MODEL: SVD7 | PRODUCT CODE: 701109 | 06/2020
11
AFTER SALES SUPPORT
1300 886 649
AUS
MODEL: MDR70-VR031 PRODUCT CODE: 61494 06/2018
Installation (Cont.)
Freestanding, floor level installation
• If you want to use the dryer on the
floor level, place the appliance in a ventilated area.
• Make sure the floor surface is firm, flat, dry and stable, and there is an appropriate
wall outlet nearby. Do not place the appliance on soft material such as foam, plastic
or carpet, as this will block the air intake.
• At least 10cm of clear space is required between the dryer and any wall(s) (Fig. 1).
• For ventilation purposes, we recommend that there are no obstacles within 1.5m in
front of the dryer.
• The appliance must be installed level, otherwise its operation will be impaired. Use a
spirit level to ensure it is level. If your floor is slightly uneven, adjust the height using
the adjustable levelling feet at the bottom of the appliance.
• Do not place the back of the dryer near curtains or similar that can get caught up in
the exhaust air.
Fig. 1
Wall-mounted installation
IMPORTANT!
• Only mount this dryer on a structurally sound wall area that is strong enough
to hold the weight of the heater. If in doubt, consult a builder.
• The supplied installation hardware (and the following instructions) are for wall-
mounting the dryer onto a solid (masonry) wall. Please obtain expert advice (from a
builder or similarly qualified person) if you intend to mount the appliance onto any
other type of wall.
• Allow at least 5cm space between the top of the dryer and the ceiling for ease of
installation.
• Allow sufficient room to open the lid of a top load washer, if wall-mounting the
dryer above a washing machine.
NOTE: This dryer is NOT suitable for placement directly on top of a washing machine.
• Ensure the dryer is unplugged from the power supply before installation.
12
AFTER SALES SUPPORT
1300 886 649
AUS
MODEL: MDR70-VR031 PRODUCT CODE: 61494 06/2018
Installation (Cont.)
Step-by-step wall-mounting instructions
Step 1: Parts required
• Confirm that you have all the components from the wall-mounting kit (Fig. 2), plus
one extra printed control panel sticker (for use if wall-mounting upside down).
• Confirm that you have the following extra tools required:
– Drill (with a
∅
14mm drill bit)
– Phillips head screwdriver
– Another person to help you lift the dryer onto the wall.
Step 2: Preparation
• This dryer must only be installed on a solid wall.
• The distance in front of the wall must be more than 1.5m.
• If you intend to wall-mount the dryer upside down, take the additional printed
control panel (supplied) and affix it over the existing panel so that the printing is the
right way up when installed upside down.
2x Hanging brackets
2x Spacers 4x Expansion bolts 1x Positioning paper
Fig. 2
Installation (Cont.)
Installation (Cont.)
