15
MODEL: SGC62 | PRODUCT CODE: 53593 | 06/2016
Installation Cont.
Adjusting the Gascock Turn Down Setting for LPG
•
Switch the burner on and set the knob at the
minimum position.
•
Remove the control knob from the tap and place
a small bladed screwdriver in the centre of the
gascock shaft (Fig. 11).
•
Unscrew the adjusting screw, in order to
increase the gas flow or tighten the adjusting
screw to decrease the gas flow.
•
The correct adjustment is obtained when the
flame has a length of about 3 – 4 mm.
•
For LP gas, the adjusting screw must be tightly
screwed in.
•
Refit the control knob.
•
Make sure that the flame does not go out by
quickly turning from maximum flow to minimum
flow. If it does then remove the control knob and
make further adjustments to the gas flow, testing
it again once the adjustment has been made.
•
Repeat this process for each one of the gas
taps.
•
When converting from Natural Gas to LP gas
ensure that the NG regulator is removed and
replaced with the Brass Test Point Fitting
(Fig 10.) A gas regulator suitable for a supply
pressure of 2.75kPa should be at the inlet to the
appliance. Replace the old data plate with one
which is suitable for the type of gas for which the
appliance ha been regulated.
Electrical Connection
Connection:
The appliance is equipped with an electrical power cord and plug, which must be
connected to the mains electricity supply in order for the ignition to work. Insert
the power plug firmly into an appropriate electrical outlet and switch on power at
the outlet.
Wall socket:
The electric wall outlet must be properly earthed and accessible. It must be
suitable for the power drawn by the appliance. The outlet voltage and circuit
frequency must correspond to the voltage stated on the appliance rating label.
Power cord:
If the supply cord is damaged, it must be replaced by the manufacturer or a
similarly qualified person in order to avoid a hazard. The power supply cord must
not touch the hot parts of the cooktop.
Electrical work:
Should any electrical work be required associated with the electrical outlet that is
to be used for the cooktop, all such work must be carried out by an appropriately
qualified, licensed electrician.
Post Installation Checks
After the cooktops connection and before leaving, the installer must check and ensure that:
• There are no leaks in the gas supply, using a soap and water solution and/or using a manometer.
• All parts (burners, trivets, control knobs) and the gas pipe are installed correctly.
• The connection has been made to the appropriate gas supply (natural gas).
• The ignition system is working satisfactorily on all burners, both individually and combined.
• When lit, each burner produces a well defined blue flame without any yellow tipping.
• Each burner flame remains lit when the respective control knob is rotated quickly from the Maximum to the
Minimum aperture position.
Fig. 11
IMPORTANT!
Where this appliance is installed in
marine craft or in caravans, it shall
not be used as a space heater.
