AFTER SALES SUPPORT
1300 777 137
12
MODEL: IA0850 PRODUCT CODE: 51703 12/2015
Instructions (cont)
Using the Carpet Cleaner
1. Plug the cord into a power outlet and switch on at the outlet.
2. To turn the Carpet Cleaner ON, press the O/I switch to the “I”
position.
3. Step on the release pedal to lower the Carpet Cleaner into the
cleaning position. See Fig. 4.
4. While pressing the water release trigger, pull the Carpet
Cleaner in a backwards motion. Water and solution will only
be released when pressing this trigger. Let go of the water
release trigger and push the Carpet Cleaner forward on the
same path to loosen and remove waste water and solution
from the carpet. For heavy soiled areas, repeat if necessary.
When the Carpet Cleaner has been powered on, the vacuum
will continually operate until powered off.
NOTE: For best cleaning results, use a steady, moderate, forward and backward motion. Always
work from backward and forward, across the room to avoid stepping on the wet carpet.
NOTE: Do not over saturate the carpet with solution while using the Carpet Cleaner.
5. Once you have finished cleaning, turn the Carpet Cleaner OFF. Press the O/I switch to the “O”
position.
NOTE: Allow for the carpet to completely dry before walking on. If necessary to walk on, place
a towel on the area to be walked on.
NOTE: Wipe the cleaning solution from any door frames or furniture to prevent damage.
NOTE
: The Carpet Cleaner may leave a small pool of solution in the location that it was
turned off. This is normal and the excess solution can be wiped away with a white, soft
cloth. This can be minimised by releasing the water release trigger and then carrying out one
more back and forward cycle before switching OFF. This will flush out most of the residual
solution left in the tubes.
Fig. 4
The Stirling Carpet Cleaner uses water, cleaning solution and the sturdy floor brushes to loose
embedded dirt from the carpet. The Carpet Cleaner then removes this dirt and collects it in the waste
water tank.
