Stihl SP 92 T, Инструкция по эксплуатации

Страница: 19 / 32

SP 92 TC
English
17
During break-in period
A factory-new machine should not be
run at high revs (full throttle off load) for
the first three tank fillings. This avoids
unnecessary high loads during the
break-in period. As all moving parts
have to bed in during the break-in
period, the frictional resistances in the
engine are greater during this period.
The engine develops its maximum
power after about 5 to 15 tank fillings.
During Operation
After a long period of full throttle
operation, allow the engine to run for a
short while at idle speed so that engine
heat can be dissipated by the flow of
cooling air. This protects engine-
mounted components (ignition,
carburetor) from thermal overload.
After Finishing Work
Storing for a short period: Wait for the
engine to cool down. Empty the fuel tank
and keep the machine in a dry place,
well away from sources of ignition, until
you need it again. For longer out-of-
service periods – see "Storing the
Machine".
Do not remove the filter cover or replace
the air filter as long as there is no
noticeable loss of power.
If there is a noticeable loss of engine
power
N
Turn the choke knob to
g
.
N
Take out the screws (1).
N
Remove the filter cover (2).
N
Clean away loose dirt from around
the filter.
N
Remove the filter element (3).
N
Replace dirty or damaged filters.
N
Replace any damaged parts.
N
Fit the new air filter in the filter
housing (4).
N
Fit the filter cover.
N
Fit the screws and tighten them
down firmly.
The carburetor has been set at the
factory to provide an optimum fuel-air
mixture under most operating
conditions.
Adjusting Idle Speed
Engine stops while idling
N
Turn the idle speed screw (LA)
slowly clockwise until the engine
runs smoothly.
Attachment runs when engine is idling
N
Turn the idle speed screw (LA)
slowly counterclockwise until the
attachment stops running.
Operating Instructions Replacing the Air Filter
1
1
2
3
4
6162BA007 AM
Adjusting the Carburetor
0208BA036 KN