Stihl SP 92 T, Инструкция по эксплуатации

Страница: 16 / 32

SP 92 TC
English
14
to switch off the ignition. The ignition is
switched on again automatically after
the engine stops.
Function of Throttle Set Wheel
Travel of throttle trigger can be limited
with the set wheel:
–
Turn throttle set wheel in direction of
– as far as stop to limit travel to idle
speed.
–
Turn throttle set wheel in direction of
+ as far as stop to allow travel to full
throttle.
–
The preset limit can be temporarily
overridden by squeezing the throttle
trigger firmly.
Starting the Engine
N
Press the manual fuel pump
bulb (5) at least five times – even if
the bulb is already filled with fuel.
Cold engine (cold start)
N
Turn choke knob (6) and then push
it in at
g
Also use this setting if the engine has
been running but is still cold.
–
Turn throttle set wheel in direction of
+ as far as stop.
Hot engine (hot start)
N
Choke knob (6) remains in
F
position.
Cranking
N
Place the powerhead on the
ground: It must rest securely on the
engine support. Rest the gearbox
on a raised support (high mound) or
position the drive tube in the fork of
a branch. Check that the rakes are
not touching the ground or any other
obstacles.
Alternative method of starting:
N
Hold the unit securely with your left
hand on the fan housing – your
thumb should be under the fan
housing – rest the drive tube in the
fork of a branch – check that the
rakes and tines are not touching the
ground or any other obstacles.
N
Make sure you have a firm footing.
N
When starting from the kneeling
position, hold the unit with your left
hand and press it down firmly – your
thumb should be under the fan
housing.
NOTICE
Do not stand or kneel on the drive tube
since it will otherwise be permanently
bent and damaged.
5
0000-GXX-5224-A0
2.
1.
6
0000-GXX-5475-A0
414BA013 KN
414BA014 KN
414BA015 KN