![background image](http://html1.mh-extra.com/html/stihl/ht75/ht75_instruction-manual_1379547006.webp)
HT 75
English
4
Ensure that the power tool is always well
balanced and hold it by the shaft for
carrying. Do not touch hot parts of the
machine, especially the surface of the
muffler – Risk of burns!
By vehicle: When transporting in a
vehicle, properly secure your machine to
prevent turnover, damage and fuel
spillage.
Refueling
Always shut off the engine before
refueling.
Do not fuel a hot engine – fuel may spill
and cause a fire.
Open the fuel cap carefully to allow any
pressure build-up in the tank to release
slowly and avoid fuel spillage.
Only refuel the machine in a well
ventilated place. If fuel has been spilled,
immediately clean the machine – do not
allow your clothes to be splashed with
fuel. If that happens, change your
clothes at once.
The power tools may be fitted as
standard with different fuel caps.
This helps reduce the risk of unit
vibrations causing an incorrectly
tightened fuel cap to loosen or come off
and spill quantities of fuel.
Check for leaks. Do not start the engine
if there is a fuel leak – serious or fatal
burns could result!
Before starting
Check that your power tool is properly
assembled and in good condition – refer
to appropriate chapters in the User
Manual.
–
Check the fuel system for leaks,
especially the visible parts, e. g.,
fuel cap, hose connections, manual
fuel pump (only in machines with a
manual fuel pump). In case of
leakage and damage, do not start
the engine – risk of fire! Have the
machine serviced by a dealer
before using it
–
Correctly mounted guide bar
–
Correctly tensioned saw chain
–
Slide control / stop switch must
move easily to STOP or 0
–
Throttle trigger lockout (if installed)
and throttle trigger must move easily
– the throttle trigger must return to
the idle position automatically
–
Check that the spark plug boot is
secure – a loose boot may cause
sparking that could ignite
combustible fumes and cause a fire!
–
Never attempt to modify the controls
or safety devices
–
Keep the handles dry and clean –
free from oil and dirt – this is
important for safe control of the
machine
–
Adjust the harness to suit your
height and reach. Observe the
chapter "Fitting the Harness"
To reduce the risk of personal injury, do
not operate your power tool if it is
damaged or not properly assembled!
If you use a harness: Practice setting
down the machine quickly by removing
the harness or by unhooking the
machine as you would in an emergency.
To avoid damage, do not throw the
machine to the ground when practicing.
Starting the engine
Start the engine at least 3 meters from
the fueling spot, outdoors only.
Place the power tool on level ground in
an open area. Make sure you have good
balance and secure footing. Hold the
power tool securely. The chain must be
clear of the ground and all other
obstructions because it may begin to run
when the engine starts.
Your power tool is designed to be
operated by one person only. Do not
allow other persons within a radius of
15 m of your own position – even when
starting the power tool – Risk of injury!
Gasoline is highly flam
-
mable – keep away from
fire or flame – do not spill
any fuel – no smoking.
After fueling, tighten
down the screw-type fuel
cap as securely as
possible.
Place the clip lock fuel
cap (bayonet-type) in
position, turn it as far as it
will and fold the clip lock
down.
Содержание HT75
Страница 1: ...STIHL HT 75 Instruction Manual ...
Страница 2: ......
Страница 40: ...www stihl com 04583900121E 0458 390 0121 E 0458 390 0121 E englisch G ...