Stihl HT75, Инструкция по эксплуатации

Страница: 19 / 40

HT 75
English
17
The fuel cap is locked
If the oil level in the tank does not go
down, the reason may be a problem in
the oil supply system: Check chain
lubrication, clean the oilways, contact
your dealer for assistance if necessary.
STIHL recommends that maintenance
and repair work be carried out only by
authorised STIHL dealers.
If the fuel cap will not lock onto the oil
tank
The base of the fuel cap is tilted in
relation to the upper part.
N
Remove the fuel cap from the oil
tank and look at it from above
N
Fit fuel cap and twist it
counterclockwise until it engages in
the seat of the filling port
N
Continue to twist the fuel cap
counterclockwise (approx. 1/4 turn)
– this will twist the base of the cap
into the correct position
N
Twist the fuel cap clockwise and
close it – see section "Closing"
The saw chain must always throw off a
small amount of oil.
NOTICE
Never operate without chain lubrication.
If the chain runs dry, the whole cutting
attachment will be irretrievably damaged
within a very short time. Always check
chain lubrication and the oil level in the
tank before starting work.
Every new chain has to be broken in for
about 2 to 3 minutes.
After breaking in the chain, check chain
tension and adjust if necessary – see
"Checking Chain Tension".
0000-GX-0142
A0 KN
left: Base of fuel cap is tilted –
interior marking (1) is aligned
with the exterior marking
right: Bottom of the fuel cap in cor -
rect position – inner mark is
under the grip. It does not
align with the exterior
marking
002BA584 KN
1
0000-GXX-0136-A0
Checking Chain Lubrication
390BA048 KN