Stiga EW 330, Руководство оператора, Страница: 21 / 26

EN - 6
9. HANDLING AND TRANSPORTATION
Whenever the machine is to be handled, raised, transported
or tilted you must:
• Stop the machine (par.6.5) until the moving parts come to a
complete halt.
• Wear heavy work gloves.
• Hold the machine in the points offering a safe grip, taking
into account the weight and its division.
• Use an appropriate number of people for the weight of the
machine and the characteristics of the vehicle or the place
where it must be placed or collected.
• Make sure that machine movements do not cause damage
or injuries.
When transporting the machine on a vehicle or trailer, always:
• Use an access ramp of suitable strength, width and length.
• Load the machine with the motor switched off and pushed by
an adequate number of people.
• Position it so that it cannot cause a hazard for anybody.
• Fasten firmly to the device of transport using ropes or chains
to prevent it from tipping over causing damage and fuel
leaks.
Do not transport machines that can be stored in ver -
tically in such an upright position.
10. MAINTENANCE TABLE
Intervention Frequency Notes
MACHINE
Check all fasteners ; Safety checks/check controls; Check the rear discharge
guard; Check the grass catcher; Check the cutting means.
Before use par. 6.2.2
General cleaning and inspection ; Checking for any damage to the machine.
If necessary, contact the authorised service centre.
After each use par. 7.3
Replacing the cutting means. - par. 7.4.2 ***
*** The operation must be carried out by your Dealer or a Authorised Service Centre
11. PROBLEM IDENTIFICATION
PROBLEM PROBABLE CAUSE SOLUTION
1. The electric lawn mower does
not work
There is no current on the machine Check the electrical connection
2. The electric lawn mower turns off
the current
The amperage of the socket is not
sufficient
Connect the machine to a power sock -
et with sufficient amperage
There are other electrical devices in
operation
Do not connect other devices at the
same time to the same power socket
3. The cut grass is no longer collect-
ed in the grass catcher
The cutting means hit a foreign object Check if there is any damage and
contact a Service centre to replace the
cutting means if necessary.
The inner part of the chassis is soiled Clean the inner part of the chassis to
facilitate the evacuation of the grass
toward the grass catcher
4. Irregular grass cutting The cutting means is not in good
condition.
Contact the Authorised Service Centre
for the sharpening or replacement of
the cutting means
5. Excessive noise and/or vibration
is experienced whilst working
Damaged or loose parts Stop the machine and remove the
supply cable.
inspect for possible damage.
Check for and tighten any loose parts.
All checks, replacements or repairs
should be carried out by your author -
ised service centre.
Cutting means fittings are loose or the
cutting means is damaged
Stop the machine and remove the
power cable
Contact the Authorised Service Centre
for checks, replacements or repairs.