Stiga BIO-SILENT, Инструкция по эксплуатации

Страница: 9 / 14

ENGLISH
GB
the ground (cold composting).
- The material can be placed in a plastic
container, wooden crate, skeleton container or
similar (cold composting).
- The material can be placed in an insulated
compost holder. The heat is then held for longer
and the rotting process also continues during
the winter. This method produces faster results
(warm composting).
- The material can be spread directly onto the
garden (surface composting).
ADJUSTING THE SHAVING PLATE
The cutting mechanism is adjusted in the works
and does not have to be set during initial commis-
sioning.
Switch on device (switch in right position)
Turn adjusting screw in a clockwise direction with
the motor running until scraping noises are heard
and fine aluminium chips fall out of the delivery
chute. Worn points on the shaving plate are opti-
mally compensated.
This improves the cutting of the shredding
material.
MAINTENANCE
Always disconnect the plug from the
electric socket before any maintenance.
Always wear protective gloves to avoid
injury.
Generally speaking, compost grinders require very
little maintenance. In order to maintain the
efficiency of the machine and to achieve a long
service life, observe the following:
• keep the air openings clean and free of
obstructing material.
• check the customer-installed nuts and screws
(tighten if necessary).
• spray the spiral cutter after each use with an
environmentally-friendly, biodegradable spray
oil to protect against corrosion.
CLEANING
Always clean the compost grinder after each use.
Never use a high-pressure washer or
running water when cleaning the
grinder!
Brush away dirt and plant residue which may be
caught in the spiral cutter. Wipe clean the outside
of the grinder with a cloth which has been
moistened with a mild detergent and water.
SERVICE
Authorised service stations carry out repairs and
servicing. They use genuine spare parts. A
complete list of these can be found on Stiga’s
website,
www.stiga.com .
Under no circumstances may parts
other than genuine spare parts be used.
This is a requirement stipulated by the
Testing Authority. The machine is
approved and tested with these parts.
If the machine requires servicing,
repairs or maintenance which entail
dismantling of the cover, this must be
performed by an authorised service
station.
The manufacturer reserves the right to make
alterations to the product without prior
notification.
Adjusting screw