Stiga 13-7454-11, Руководство по ремонту

Страница: 36 / 123

Machines without cab
1. Remove the lighting bar/reinforce-
ment plate.
2. Remove the cover by removing the 4
screws.
3. Disconnect the electrical cables from
the lamps.
4. Remove the upper section of the
steering bracket by unscrewing the
four screws and the knob of the park-
ing brake.
5. Remove the steering bracket protec-
tion by unscrewing the two remaining
screws.
6. Remove the inner front cover by un-
screwing the two remaining screws.
7. Remove the steering wheel by knock-
ing out the locking pin.
8. Mark the position of the five hydraulic
hoses that are connected under the
power steering servo.
The letters in the figure are stamped
on the bottom, beside the respective
A
sockets.
Note Take care to mark the hoses be-
fore removal.
9. Slacken off and remove the hoses.
Take care to use plugs for both the
hose and the unit so that dirt cannot
penetrate the system.
No contaminants must enter the
hydraulic system. This causes
serious damage to components
of the systems.
10. Remove the servo by unscrewing the
four upper screws A.
6x
2x
2x
4x
2x
WORKSHOP MANUAL
TITAN
Chapter
3 - Steering system
EDITION
2018
Page
3 4