Stiga 13-7454-11, Руководство по ремонту

Страница: 11 / 123

1.6 Service
Each new machine is supplied with a serv-
ice book. The service log should be
stamped at every service carried out by an
authorised workshop. The service book is
part of an active aftermarket program and
must be stored in a safe place during the
lifetime of the machine. The service book
must accompany the machine if it is sold as
used.
The service points are given in the table
below. Descriptions of how the proce-
dures are to be carried out are given after
the table.
WORKSHOP MANUAL
TITAN
Chapter
1 - General instructions
EDITION
2018
Page
9
Service point
Hours of operation/Calendar
months
See the
instructions
1st time Interval
Water separator, check 50/-
in the
instructions for
use paragraph
maintenance
Filter in water separator, cleaning
Fuel filter, replace 400/-
Tyre pressure, check, adjust
Engine oil, filter, change 50/12 200/12
Hydraulic oil, change/clean 400/12
Wheel motors , change oil 50/12 200/12
Belt transmissions, check 50 200/-
Cooling system, change coolant 1000/24
Battery, check 50/-
Air filter, clean pre-filter 200/-
Air filter, change inner filter 200/-
Lubrication 50/-
Tightening / control of hydraulic cou-
plings and hydraulic tubes
50 50/-
Adjusting valves 1000/-
Grinding valves 2000/-
Tank venting valve, change/ clean 1000/24
Check the correct tightening of the fix
screw of the lift arms support
50/12 400/12
See the
drawing (1)
Check the tightening torque of the
screws (A) and (B) of the joint.
50/12 400/12
See the
drawing (2)
1 2
ATTENTION
Correct torque
385 Nm