Stiga 13-7454-11, Руководство по ремонту

Страница: 31 / 123

2.4.5 Removing the cab
Remove the cab as follows:
1. Remove the little side front cover by
turning the screw with the bracket.
See “2.2.2” Disconnect the switch that
goes to the cab marked Cabin.
2. Slide the seat as far forward as possi-
ble.
3. Remove the steering wheel by remov-
ing the screw on the steering wheel
shaft.
4. Remove the document holder by un-
screwing the screws (4x).
5. Remove the air intake by unscrewing
the screws (2x).
6. Remove the mat on the floor.
7. Secure the cab in the lifting device in
the four mountings A (2x), B (2x) on
the roof. Use lifting eyes, 12 mm with
the DIN 580 standard.
8. Slacken off the front screws C (4x)
that are below the windscreen inside
the cab.
9. Slacken off the screws D (8x) that are
(4x) and (4x) on each side of the seat.
10. Then carefully lift off the cab.
Note
The machine must not be driven
without a cab unless a roll bar
Note When lifting do not forget to
take the weight of the cab,
which is 146 kg, into considera-
tion.
has been installed in accord-
ance with the EU directive.
Reinstall the cab in reverse order. After
installation check the light settings, see
”2.4.4”.
Note!
It is important that the cab is re-
moved in accordance with the in-
structions so that no components
are damaged.
A
B
WORKSHOP MANUAL
TITAN
Chapter
2 - Chassis and bodywork
EDITION
2018
Page
2 9