OpEraTiON
General information
4
| WPE-I H(K)W 230 Premium
www.stiebel-eltron.com
OpEraTiON
1. General information
The chapters "Special information" and "Operation" are intended
for both users and qualified contractors.
The chapter "Installation" is intended for qualified contractors.
Note
Read these instructions carefully before using the appli-
ance and retain them for future reference.
Pass on these instructions to a new user if required.
1.1 Relevant documents
Operating instructions for the WPM heat pump manager
Commissioning instructions for the WPM heat pump
manager
Operating and installation instructions for system com-
ponents
1.2 Safety instructions
1.2.1 Structure of safety instructions
!
KEYWORD Type of risk
Here, possible consequences are listed that may result
from failure to observe the safety instructions.
f
Steps to prevent the risk are listed.
1.2.2 Symbols, type of risk
Symbol
Type of risk
Injury
Electrocution
Burns
(burns, scalding)
1.2.3 Keywords
KEYWOrD
Meaning
DANGER
Failure to observe this information will result in serious
injury or death.
WARNING
Failure to observe this information may result in serious
injury or death.
CAUTION
Failure to observe this information may result in non-seri-
ous or minor injury.
1.3 Other symbols in this documentation
Note
General information is identified by the adjacent symbol.
f
Read these texts carefully.
Symbol
Meaning
Material losses
(appliance damage, consequential losses and environmen-
tal pollution)
Appliance disposal
f
This symbol indicates that you have to do something. The ac-
tion you need to take is described step by step.
1.4 Information on the unit
Symbol
Meaning
Refrigerant with low flammability
Inlet / intake
Drain / outlet
Heat source
Heating
Potable water
Never cover the appliance
1.5 Units of measurement
Note
All measurements are given in mm unless stated oth-
erwise.
1.6 Standardised output data
Information on determining and interpreting the specified stand-
ardised output data.
1.6.1 Standard: EN 14511
The output data specifically mentioned in text, diagrams and
technical datasheets has been determined in line with the test
conditions described in the standard shown in the heading of this
chapter. However, there is a partial deviation from this norm in
the output data for inverter heat pumps, as this concerns partial
load values. The associated percentage weighting in the partial
load range can be found in EN 14825 and EHPA quality label reg-
ulations.
!
!
Содержание WPE-I 04 HKW 230 Premium
Страница 29: ...Installation Specification www stiebel eltron com WPE I H K W 230 Premium 29 ...
Страница 45: ...www stiebel eltron com WPE I H K W 230 Premium 45 NOTES ...
Страница 46: ...46 WPE I H K W 230 Premium www stiebel eltron com NOTES ...
Страница 47: ...www stiebel eltron com WPE I H K W 230 Premium 47 NOTES ...