iNSTallaTiON
preparations
6
| HSBB 200 S (GB) www.stiebel-eltron.com
10. Preparations
10.1 Installation site
!
Material losses
Never install the appliance in wet rooms.
Install the appliance near the draw-off point in a dry room free
from the risk of frost. To reduce line losses, keep the distance short
between the appliance and the heat pump.
Ensure the floor has sufficient load-bearing capacity and evenness
(for weight, see chapter "Specification / Data table").
The room must not be subject to a risk of explosions arising from
dust, gases or vapours.
If you are installing the appliance in a boiler room together with
other heating equipment, ensure that the operation of other heat-
ing equipment will not be impaired.
Minimum clearances
≥250
≥400
≥800
≥100
≥500
≥100
≥500
D
00000
70
86
4
The minimum side clearances can be swapped to left or right.
10.2 Transport and handling
!
Material losses
Store and transport the appliance at temperatures be-
tween -20 °C to +60 °C.
Handling
If possible, transport the appliance to the installation site on the
non-returnable pallet. Alternatively, transport the appliance using
a sack truck, creeper board or tension belt, which can be posi-
tioned around the front adjustable feet as a carrying strap.
f
f
Undo the 4 screws from the non-returnable pallet.
D
00000
55
51
9
f
f
Tilt the appliance and wind the 4 adjustable feet into the
appliance.
f
f
Lift the appliance off the pallet. For a better hold dur-
ing transport, use the recessed grips on the rear of the
appliance.
11. Installation
11.1 Positioning the equipment
f
f
When positioning the appliance, observe minimum clearanc-
es (see chapter "Preparations / Installation site").
f
f
Use the adjustable feet to compensate for any unevenness in
the floor.
11.2 Removing / fitting the front casing
When removing the cover, take care with the cable connections
between the appliance and the electronic operating assembly.
D
00000
70
87
9
f
f
Remove the 2 screws on the cover.
f
f
Lift the cover.
