9
Resistors have a low profile, sitting closer
to the board than taller components, so
installing these now will make installing
other parts easier later on.
INSTALL
6 MORE
RESISTORS
4
47
n
J
47
n
J
.1
J6
3
47
n
J
47nF capacitor (3)
#7307
100nF capacitor (1)
#7304
100µF capacitor (1)
#7339
100pF capacitor (1)
#7326
.1J63
101J
100V
47n
J
10 0 u F
INSTALL 6
CAPACITORS
5
The 100μF capacitor shown below is polarized and must be installed in the correct
orientation. Note the stripe running the length of the cap; this identifies the negative (–)
lead (the negative lead is also shorter).
On the printed circuit board, each capacitor has a square-shaped eyelet marked positive (+).
The negative lead’s eyelet is round.
The remaining (3) capacitors below are not
polarized. However, best practice is to solder
these caps in place all facing the same direction.
68K resistor (2)
#7380
Blue Gray Black Red Brown
2.2M resistor
(1
)
#7368
560K resistor (1)
#7420
Green Blue Black Orange Brown
Red Red Black Yellow Brown
4.7K resistor (1)
#7359
Yellow Violet Black Brown Brown
160K resistor (1)
#7415
Brown Blue Black Orange Brown
