12
w
w
w
.s
te
w
mac
.c
om
47
n
J
.1
J6
3
47
n
J
47
n
J
IN GND SW OUT
The printed circuit
board is held in place by
the LED leads and the
leads to the footswitch.
Pass the longer positive lead of the LED
through the eyelet marked “A” and the
shorter negative lead through the eyelet
marked “K”. Solder these leads in place.
Install the footswitch through the top of
the case and slide a washer onto it from
the outside. Use a 14mm wrench to tighten
it up. The footswitch is the effect bypass
switch that turns the pedal on.
Do not connect any of the lead wires at this
point.
11
INSTALL
PRINTED
CIRCUIT
BOARD
5mm LED mounting bez
el (1)
#7432
5mm white LED (1)
#7422
case
The LED mounting bezel consists of two main parts:
A ring that the LED fits into and a plastic plug that goes
over the LED from the back side to keep it in place.
Install the mounting bezel through the top of the
enclosure from the inside. Slip a lock washer and nut
on and tighten it up using a 3/8" socket. Insert the
LED into the bezel so the flat side (the shorter lead)
faces to the right side of the enclosure when seen
from inside. Feed the leads through the plastic plug,
and press the plug down until it’s tight in the bezel.
The LED will be held in place when you solder the
leads to the switches and printed circuit board. For
a more secure mount, you can run a bead of clear
silicone adhesive around the plastic plug.
12
INSTALL
LED
INDICATOR
LIGHT
Like some of the caps and diodes,
the LED is polarized and has to be
installed in a specific direction. The
negative lead of the diode has a flat
edge and is shorter than the positive.
+
+
