13
12
INSTALL
THE
INPUT JACK
Insert the input jack into the left side hole in the top of the enclosure with the tip
connection facing down, as shown in the diagram. Add the washer, and thread the nut
onto the shaft enough so that the jack can rotate freely. You may need to rotate the jack
to provide easier access to setting the solder joints.
Solder the left-most wire at the top of the
printed circuit board to the input jack lug that
corresponds with the sleeve connection. The
sleeve lug should be the one closer to the DC
jack.
Solder the 4" wire on the left side of the
breakout board to the lug of the input jack that
corresponds with the tip connection. The tip lug
should be the one closer to the outside wall of
the enclosure.
Once the solder has cooled, orient the jack as
shown in the diagram, making sure none of the
connections on the jack are touching any other
components, and tighten the nut on the jack.
13
SLEEVE
SLEEVE
INSTALL
THE DC
POWER JACK
Insert the DC power jack into the center hole in the top of the enclosure making sure
the longer of the two lugs is on the left. Use a 14mm wrench on the included nut to
secure the jack into the enclosure.
Solder the inside left wire to the longer lug of the DC jack.
Solder the inside right wire to the shorter lug of the DC jack.
