14
14
INSTALL
THE OUTPUT
JACK
Insert the output jack into the right side hole in the top of the enclosure with the tip
connection facing up, as shown in the diagram. Add the washer and thread the nut
onto the shaft enough so that the jack can rotate freely. You may need to rotate the
jack to provide easier access to setting the solder joints.
Solder the right-most wire at the top of the
printed circuit board to the output jack lug
that corresponds with the sleeve connection.
The shield lug should be the one closer to the
DC jack.
Solder the 4" wire on the right side of the
breakout board to the lug of the output jack
that corresponds with the tip connection. The tip
lug should be the one closer to the outside wall
of the enclosure.
Once the solder has cooled, orient the jack as
shown in the diagram, making sure none of the
connections on the jack are touching any other
components, and tighten the nut on the jack.
Shield lu
g
Tip conne
ctio
n
Tip lu
g
Shield conne
ctio
n
COMPLETED
VIEW
15
w
w
w
.s
te
w
mac
.c
om
47
n
J
.1
J6
3
47
n
J
47
n
J
IN GND SW OUT
With the output jack secured, this is what your pedal
should look like.
Congrats on a job well done.
Now, simply attach the bottom of the enclosure with
the included screws, plug it in, and bend some tone!
