Final Assembly Continued
☐
Secure motor mount to hull using 8 of the
provided #2 x 1/2” screws. Without
compressing gasket, use screws to snug
mount to gasket surface then apply only 1/2
turn to each screw to mildly compress gasket.
☐
Using small needle nose pliers bend a “Z” in
one end of the 0.045 in. x 6 in. music wire.
☐
Trim servo control arm to proper length and
Install provided Mini EZ Connector (DUB845).
☐
Install Z bend end of 0.045 in. wire through
center hole of rudder control arm then bend
and pass through Mini EZ Connector in servo
as illustrated below. Center rudder then
secure grub screw in Mini EZ Connector.
☐
Rudder is retained to rudder post with second
rubber bushing as illustrated.
☐
Install hook and loop tape to (not provided) to
battery tray and along inside edge of
electronics hatch for receiver.
© 2010 Stevens AeroModel all rights reserved. V2.0 (11.10.2014)
Page 17 of 25
